V-2 Installation Instructions

V-2 Installation Instructions

Refer to the diagram below and perform the following steps.

Prepare ESC Board

Note: For battery voltages greater than 10 volts, cut traces with x-acto knife as shown in detail.
Turn ESC power switch on and remove plastic switch slider to prevent it from being switched off.
Unsolder and remove the ESC battery wires from the ESC board.
Unsolder and remove the ESC motor out wires from the ESC board.

Connect ESC to V-2

Solder the 4 wires between the ESC board and the V-2 as shown below.
Solder the motor wires as shown.
Solder the battery wires as shown. Use an inline connector to the batteries to disconnect the power when not in use.

New V2 board

V2 undergoing testing